Window Tint

1. Clean windows thoroughly. Then scrape off any residue or build-up with a single-edge blade. Measure window and cut a piece of film to window dimensions, leaving an extra 1/4" all around. This will be trimmed later.		Caution: Film should be applied only to windows rear of the driver. Check on local and state legislation before applying Limo-Tint film products.
			2. Place a masking tape tab on both sides of the material and carefully pull apart in opposing directions. This peels off liner to expose adhesive.
3. Using the "Wet Method" described in the graphics application section of these tips, spray both the window and the adhesive side of the film. Place film carefully on window. Spray the exposed side of the film before squeegeeing. This will provide the lubricant for the squeegee and help prevent scratching.
		4. Working from center out, squeegee liquid out from under film. 5. Carefully trim excess film around window edge.