Striping
Striping Application Instructions

1. Be sure surfaces are clean and apply at temperatures of 60º-80º F (16º-27º C). Avoid striping in direct sunlight.
		2. Remove backing paper and apply the first 5" of striping beyond where you want the stripe to begin.

		3. Striping should be applied to each panel of the vehicle in a single pass. Reposition with a snap motion, without pulling. Hold tight, but don't stretch. Make rounded turns with your stripe, and avoid sharp points.
4. When the stripe is in the correct position, rub the surface with your thumb, finger, or squeegee, following the direction of the stripe, to ensure final adhesion. Trim tape 1/8" short of doors and panel edges. Allow 72 hours before waxing or washing.

Create your own designs, the possibilities are up to you!