Graphics Application Instructions

1. Be sure surfaces are clean and apply at temperatures of 60-80° F (16-27° C). Avoid striping in direct sunlight.
			2. Remove the liner from the graphic. Spray the "WET" solution (see the Install Guide) to the adhesive side of the graphic, as well as to the area of the vehicle where the graphic will be installed.
3. With the graphic in final postion, gently squeegee the water out using easy overlapping strokes. Start in the center and work towad the outside edge allowing the graphic to lay down naturally. Do not sistort the image. When all liquid has been squeezed out allow graphic to set for 5-10 minutes.
		4. Remove masking carefully at a 180° angle to the application surface. If the graphic appears to be lifting, gently replace the top carrier and resqueegee over area. Remove air bubbles in graphic by puncturing vinyl with a pin or needle and squeegee out air towards puncture. Trim graphic just short of door breaks, door handles and panel eges. Do not wrap vinyl around edges. Allow 48-72 hours cure time for proper adhesive bond.